TES-Taiwan

TES-92 ElectroSmog Meter

Category: EMF Tester

ELECTRICAL SPECIFICATIONS

Sensor type Electric field (E)
Frequency range 50MHz to 3.5 GHz
Directional characteristic Isotropic, 3-dimensional
Measurement range (CW signal>50MHz) 20mV/m to 108.0V/m
Absolute error(@1V/m and 50MHz) ± 1.0dB
Frequency response (taking into account typ. CAL factor) ± 1.0dB (50MHz to 1.9 GHz) , ±2.4dB(1.9GHz to 35GHz)
Isotropy deviation Type. ±1.0dB 於 f>50 MHz
Overload limit 4.2W/m2 (40 V/m)
Temperature response(0 to 50 ℃) ± 1.5dB
Note

Unless otherwise stated, all specifications hold under the following assumptions:

Sinusoidal signals; device in far-field of a source; probe head pointing toward source; ambient temperature +23 ℃±3 ℃;relative air humidity 25% to 75%.

GENERAL SPECIFICATIONS

Measurement method Digital , triaxial measurement
Directional characteristic Isotropic, triaxial
Measurement range selection One continuous range
Display resolution 0.1mV/m, 0.1 μA/m, 0.1 μW/m², 0.001 μW/cm²
Setting time Typically 1s ( 0 to 90% of meas. value)
Display refresh rate

Typically 400mS

Display type LCD 4 digit
Audible alarm Buzzer
Measurement units mV/m , V/m , μA/m , mA/m , μW/m² , mW/m² , μW/cm²
Measurement display value Instantaneous measured value, maximum value or average value since power-on.
Measurement alarm function Adjustable threshold with ON/OFF
Measurement calibration factor CAL Adjustable
Manual data memory and read storage 99 sets ( only recall by meter )
Battery 9V
Battery life >15 hours
Accessory 9V battery, carrying case & manual
Ask about this product